Page 2 of comments on Get To Know Mini Moto
by Matt Tong
Comments Page 2 of 3: Previous 1 2 3 Next
my mini motor wont go when i rev it it just revs and doesnt move why is this?you need to put a new clutch in. i garenty it will work!
my minimoto was working fine and then the engine started chuging soon as i put the revs on then it cut out it hasnt run since i got a new spark plug because the other one was oily, and cleaned the whole bike and it still wont start could it be the pull start or the cord that runs to the spark plug?m8 had the same prob get a battery and take of pull start and you should see a box with to cables get the batter (one with a terminal)and get the other side of it and touch it and then put the pull start back on and it should work if not keep doing it till it does
my mini moto smokes alot white smoke tho y is this?your mix is to rich in oil
^^^ to rich. turn the white thing next to the choke clockwise
i have a mini motor and not sure what type of engine it has so i was wondering how can you tell.
my mini moto gives a lot of blue smoke.. what is this a sign of?my mini dirt bike has that according to my m8 whn i was riding it
my mini moto is leaking from the pipe that runs down the side of the carb so i have replaced the carb and it is still doing the same thing what could be wrong ?the pipe is an over flow pipe so jus means it is too full. try a little less petrol..
for comment above u have 2 stroke stuck in the jet just take off the tap clean it then gewt a pipe ot a straw put it over th hole blow really hard on both holes then put the tap back on put some unmixed fuel in it start up if it stil leaks take off the 2 bolet n the botten take out all the fue then put back on put unmixed fuel on it if it starit cut it off and put some mixed fuel init and it should work i did that a couple of times on my bike if none of that works put s stick or some thing to cover the over flow (the pipe) then start it up it shound work then ptake off the stick then star upagain and it should clean the jet and if that doesnt work put fue in the bike and leve it in there for a bout 2 -5 mins then try starting the bike it should break down the oil and should work hope that helps you
My mini moto is the origami b1 rep. Just been out on it last night for the first time in about a month or so. Was running fantastic till about 20 mins into the run it completely cut out when i was reving. No chuging or anything just a straight engine stop. The bike would then not start again for about 5-10 mins. Once restarted it would run just as good but cut out again another 10-20 mins into run. Any ideas would be great, cheers.
when i rev my mini moto it makes a reving noise the harder u rev the louder the noise but the mini moto does not move please tell me why !
We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.
Comments Page 2 of 3: Previous 1 2 3 Next